Beam (Trovac) Circuit Board...
$86.99
Product details
This Beam circuit board, built by Trovac, the Quebec manufacturer behind these Beam branded canisters, is part 901V, the board Trovac's own service documentation lists as ELECIR901V with a 15 amp rating, and it serves four Beam power unit models: 205A, 345A, 475A, and 495A. It governs the unit’s switching and power circuitry, so it is the component that translates a signal from a wall inlet valve into the motor turning on.
A unit that refuses to start, loses speed control partway through a cleaning session, or behaves erratically when a hose is connected is commonly linked to a failed board, not the motor, since the motor rarely fails on its own. Because 901V is built to match this specific group of models, confirming your unit’s model number against the four listed here is the key step before ordering.
Swapping in a matched replacement board restores the unit’s normal switching behavior without disturbing the motor or the tubing connections, since the board mounts and wires independently of both.
Trovac publishes service pages for the Beam 475 and 495 that list this same board along with its connection diagram, and that diagram is worth keeping on hand during the swap, since the low-voltage leads and motor connections must land on the correct terminals for the unit to run. Ordering by model number rather than by general appearance is still the surest way to get a matched board, and checking the nameplate against the four models listed here takes far less time than an install that stalls on a close but wrong part.
- Part: 901V
- Fits: Beam models 205A, 345A, 475A, and 495A
- Type: Circuit / control board
- Rating: 15 amp (Trovac ELECIR901V)
- Label: Trovac-built Beam board