SEBO Screw C 2.9 x 16 for D...
$6.99
Product details
At 16 mm this is the long member of the 2.9 mm tapping screw family, sized to reach through a moulding and still take a useful bite in the boss underneath. SEBO lists it for the D series machines and supplies it one at a time under part number 1000. Like the rest of the C-series tapping screws it drives straight into plastic and holds without a nut behind the joint.
Length is not cosmetic on a fastener like this. Fit something shorter and the head pulls up against the surface before the thread has properly engaged, so the joint feels tight through the driver while holding almost nothing. A week later the panel has drifted loose again and the obvious conclusion, that the screw was faulty, is the wrong one. Fit the length the design calls for and the clamping load lands where it was meant to.
- Part number: 1000
- Fits: SEBO D series
- Size: 2.9 mm diameter, 16 mm long
- Type: C tapping screw, cross-recessed pan head
- Thread: self-tapping into the moulded boss
- Sold: each
- Shorter 2.9 mm screws: part 100 at 9.5 mm and part 107 at 13 mm
Replace one when the recess has rounded under a slipping driver, when the screw spins in its hole without drawing down, or when the original went missing during a strip. If a new screw of the correct length still spins, the fault has moved to the boss rather than the fastener, and driving a longer screw into it only splits the plastic.
Lay the old screw next to the new one before fitting. The 2.9 mm family runs from under 10 mm to over 20 mm and the heads look identical across the whole set, which is why so many of these end up in the wrong hole. Searches for a SEBO D series body screw, a 2.9 x 16 tapping screw or a genuine SEBO 1000 fastener all land on this part. Genuine SEBO hardware from an authorized dealer, on its way to you in 2-5 business days.