Clean Obsessed 35 ft x 1-3/...
$195.99
Product details
This attachment kit is sized to fit the Clean Obsessed low-voltage system, built around a button-lock hose fitting with a 1-3/8 inch cuff. Working the on/off button right at the handle means you are not walking back to a wall switch every time you change rooms.
Thirty-five feet of hose gives one inlet enough reach to cover several rooms in most single-story layouts before you need to move to the next port. A telescopic wand extends to match your height, and the set rounds out with five floor and cleaning tools plus hangers that keep the wand and hose off the floor at the inlet.
- Compatible with: Clean Obsessed low-voltage inlets
- Hose length: 35 feet, button-lock connector, 1-3/8 in cuff
- Wand: Telescopic, adjustable length
- Tools: 5-piece set for floors, upholstery, dusting, and tight spaces, plus storage hangers
Low voltage hose failures usually show up as the button-lock function cutting out intermittently before the hose itself gives out, since the fine conductor wires molded into the hose wall take more cyclic flexing over years than the outer covering does. If the motor no longer starts reliably from the handle button but does start from the wall switch, suspect the hose's internal wire before assuming the receiver board at the power unit has failed.
Button-lock hardware only mates with other button-lock components, so if you are replacing a worn-out hose on an existing Clean Obsessed setup rather than outfitting a new one, check that your current wand and tools use the same fitting before ordering the hose separately. Listed under SKU 11213CCV.